Download Free HP HPE0-V15 Exam Questions & Answer [Q25-Q43]

NO.25 Refer to the exhibit.

You observed some high temperature alerts on a switch shown in the middle rack of the exhibit. The cooling in the data center is following best practices for the layout in the exhibit. The switch is an HPE 5945 series switch, and all the fans are operating normally. The switch is racked so that its ports face the rear of the rack. The administrator noticed the fan modules have red handles.
What should the administrator do to resolve the issue?

NO.26 A customer is subject to regulatory requirements and their data is highly sensitive.
Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?

NO.27 A customer needs to consolidate software, hardware, and backup in a single integrated solution to reduce the cost and complexity of their IT environment Which solution meets the customer needs?

NO.28 A customer has a small business office and is concerned that the local storage in their current ProLiant Gen 10 server with a Linux OS Is reaching maximum capacity Which solution should you recommend to expand the customer’s data storage capacity?

NO.29 Where would a customer go to run the SSD wear Gauge report on an HPE ProLiant server?

NO.30 A customer requires an entry-level, all-flash system with predictable performance at the lowest possible price. They have performance-sensitive workloads that require speed and efficiency.
Which HPE storage system needs the customer’s requirements?

NO.31 A customer is facing high and unpredictable latency on an HPE ProLiant DL380 Gen10 server equipped with P408i-a controller Which tool can display an Array Diagnostic Report?

NO.32 A customer needs a server memory subsystem that meets the following requirements:
approaches the speed of traditional DRAM
ensures high capacity, high performance, and ongoing data safety in case of a power failure Which HPE memory feature meets the customer needs?

NO.33 You need to change BIOS configuration settings without rebooting a server.
Which system utility should you use?

NO.34 You configured a port on an HPE FiexFabric 5900 series switch that is connected to a VMware ESXi server to support multiple VLANs interface Ten-GigabitEthernet 1/0/11 description server ESXiOl-ethl port link-type trunk port trunk permit vlan 50 port trunk permit vlan 2 port trunk pvid vlan 50 Given the configuration above, what should happen to any untagged traffic coming from the VMware ESXI host?

NO.35 A small, expanding law firm wants to replace its single Windows server
The server will be kept in their library without a rack. They want a server that allows for internal storage growth and is capable of adding PCI adapters.
Which HPE server model type should you recommend?

NO.36 A customer plans to use HPE ProLiant servers for line-of-business applications. They want to configure the servers to increase reliability.
Which workload profile should the customer use?

NO.37 What does the term composable mean when applied to HPE infrastructure?

NO.38 A customer purchased a Nimble HF20 a year ago They are experiencing an issue with a few of their VMware servers in the RTP Nimble date center and asked that you make a recommendation based on the data in infoSight.
What should you recommend’?

NO.39 What is the process or writing data to two locations within a single array in real time?

NO.40 Match the Networking Product Family to the appropriate use case:

NO.41 Read the question, and then refer to the exhibit.
<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?

NO.42 A customer considers a new HPE ProLiant DL380 Gen10 as a hardware platform for their application and requires maximum physical security.
For each security-related server components, identify whether it needs to be ordered separately, or whether it is included as part of the server solution.

NO.43 For which virtualization management products does HPE OneView offer integration plug-ins1? (Select two.)