2023 Valid GB0-191-ENU Real Exam Questions, practice H3CNE [Q224-Q242]

Q224. If the public network address of the NAT device is dynamically allocated by the operator through ADSL, in this case, you can use ______.

Q225. A company needs to connect to the WAN to form a corporate network, and the bandwidth of the connection is required to be greater than 1Mbps. Which of the following interfaces and protocols are available?

Q226. Among the following statements about Easy IP, the correct one is ______. (Multiple choice)

Q227. The routing table seen on an MSR router is as follows:
Destination/Mask Proto Pre Cost NextHop Interface
6.6.6.0/24 Static 60 0 100.1.1.1 GE0/0
8.8.8.8/32 Direct 0 0 127.0.0.1 InLoop0
20.1.1.0/24 Static 60 0 100.1.1.1 GE0/0
30.0.0.0/8 RIP 100 1 100.1.1.1 GE0/0
Then the correct analysis of this routing table is ______.

Q228. If all 0 and all 1 subnets can be used as effective subnets, the class C address 192.168.1.0 is subnetted with a 26-bit subnet mask, and the number of effective subnets that can be divided is ______.

Q229. The customer’s network connection looks like:
HostA—-GE0/0–MSR-1–S1/0—–WAN—-S1/0–MSR-2–GE0/0—-HostB
The two MSR routers are interconnected through the WAN, and the physical connection is now normal. The address of interface S1/0 of MSR-1 is 3.3.3.1/30, and the address of interface S1/0 of MSR-2 is 3.3.3.2/30. Now the following 4 static routes are configured on MSR-1:
ip route-static 192.168.1.0 255.255.255.0 3.3.3.2
ip route-static 192.168.2.0 255.255.255.0 3.3.3.2
ip route-static 192.168.3.0 255.255.255.0 3.3.3.2
ip route-static 192.168.4.0 255.255.255.0 3.3.3.2
The 192.168.0.0/22 ​​subnet is the LAN user network segment of MSR-2.
So which of the following descriptions are wrong? (multiple choice)

Q230. As shown in the figure, there are 4 ways to divide the OSPF area, which one is correct? (multiple choice)

Q231. Which of the following options describes the parameters that can uniquely determine a TCP connection?

Q232. Xiao L is a senior IP network expert, determined to develop a new dynamic routing protocol. Which of the following should be included in the working process of a routing protocol? (multiple choice) (multiple choice)

Q233. The following description of the characteristics of VTY in H3C equipment is correct ______.

Q234. Which of the following is the correct IPv6 address? (multiple choice)

Q235. The correct statement about the IP address below is ______. (Multiple choice)

Q236. When the source host pings the destination device, if the network works normally, the destination device will respond to the source host with an ICMP_____ packet after receiving the message.

Q237. The IPv6 site local address belongs to the ______ address type.

Q238. To set a subnet mask so that 192.168.0.94 and 192.168.0.116 are not in the same network segment, the subnet mask used may be ______. (Multiple choice)

Q239. The port Ethernet1/0/4 of the switch SWA is connected to a router.
If the administrator wants to disable the spanning tree function on this port, which of the following commands needs to be used?

Q240. A router is connected to the operator’s network through the Serial1/0 interface. To configure a default route on this router to achieve the purpose of accessing the Internet, which of the following configurations must be correct and effective?

Q241. In a PPP connection, what is wrong about NCP is ______.

Q242. The Ethernet frame exchange on the switch relies on the MAC address mapping table, which can be established by ______. (Multiple choice)