[Mar-2026] BICSI INST1-V8 Test Engine PDF – All Free Dumps from TestSimulate [Q50-Q69]

NO.50 Which of the following components is used to bond the electrical system’s grounding electrode system to the PBB?

NO.51 What type of connector is used with ribbon cable?

NO.52 A grey backboard should be used to identify _____ backbone cable?

NO.53 Which of the following tend to cause sheath damage during cable pulling?

NO.54 How far should the top of a ladder extend above the roofline?

NO.55 Which type of cabling is installed between a main cross-connect (campus distributor) and an intermediate cross-connect (building distributor)?

NO.56 Which of the following fire ratings refers to the time period that the unexposed surface of a firestop assembly does not exceed 180 degrees C (325 degrees F) above its initial temperature?

NO.57 Which of the following tools is a low-cost cable verifier that can be used to test for opens, shorts, crossed pairs, and miswires in 4- pair cables?

NO.58 What is the primary purpose of firestopping?

NO.59 What is the maximum pull force for four-strand optical fiber?

NO.60 Which topology uses a linear configuration that places all network devices on one length of cable?

NO.61 What is the minimum recommended amount of vertical clearance for open-top cable supports?

NO.62 Which of the following is used to equalize potential differences between the SBB on the same floor?

NO.63 Which of the following topologies is the recommended topology for distribution systems in campus environments?

NO.64 Which of the following markings is used for non-conductive optical fiber general-purpose cables?

NO.65 Which of the following is a building-serving space that houses large pieces of common active equipment?

NO.66 Which of the following is a benefit of air-blown optical fiber cable?

NO.67 Which of the following steps should be performed first when an installer is pulling optical fiber cable?

NO.68 How many cycles are in 10Hz?

NO.69 Light pulses in optical fiber cables are subjected to a loss in power as the light pulses travel along the optical fiber. Which of the following terms is used to describe this phenomenon?