Get Prepared for Your H12-811-ENU Exam With Actual 454 Questions [Q91-Q115]

NO.91 Regarding the corresponding relationship between the access control list number and type, which of the following description is correct?

NO.92 In the network shown in the figure below, which of the following commands can be entered on the router to enable host A to ping host B? (Multiple choice)

NO.93 Which of the following port states is not included in the RSTP protocol?

NO.94 Which of the following fields does the MPLS header include? (Multiple choice)

NO.95 As shown in the network below, all switches enable STP protocol. Disable SWA’s G0/0/2 port configuration BPDU sending function, SWC G0/0/1 re-converges to become the root port, about this process, which of the following statements are correct? (Multiple Choice)

NO.96 In the network shown in the figure below, from a security perspective, router A refuses to receive OSPF packets and ICMP packets received from the cO/0/1 interface. Which of the following commands can achieve this requirement? (Multiple Choice)

NO.97 On the AC, you can manually specify the source address or source interface of the CAPWAP tunnel.

NO.98 What address does 192.168.1.127/25 represent?

NO.99 Which WLAN security policies support the link authentication method of Open mode? (Multiple Choice)

NO.100 Which of the following description about DD packets and LSA of OSPF is correct? (Multiple choice)

NO.101 The MAC address table of the existing switch is shown in the figure. Which of the following statements are correct?

NO.102 AC uses CAPWAP control tunnel to transmit management messages to FIT AP.

NO.103 Regarding the control plane of the device, which of the following statements is correct? (Multiple choice)

NO.104 The Layer 2 switch is a data link layer device, which can identify the MAC address information in the data frame, forward data according to the MAC address, and record these MAC addresses and corresponding port information in its own MAC address table.

NO.105 What are the advantages of using dynamic host configuration protocol DHCP to assign IP addresses? (Multiple choice)

NO.106 The host’s IPv4 address is 200.200.200.201/30. Which of the following hosts has an IPv4 address and its communication does not need to be forwarded by a router?

NO.107 f a windows host is started for the first time, if the IP address is obtained by DHCP, then what is the source IP address of the first packet sent by this host?

NO.108 The output information of the sub-interface of a router aggregate port 1 is shown in the figure. Based on this information, which of the following statements are correct? (Multiple Choice)
[Router A]display Interface Eth-Trunk 1.100
Eth-Trunk1.100 current state : UP
Line protocol current state : UP
Last line protocol up time : 2019-03-04 10:22:40 UTC -08 :00
Description: HUAWEI, AR Series, Eth-Trunk1.100 Interface
Route Port, Hash arithmetic : According to SIP-XOR-DIP, Maximal BW: 2G, Current BW: 2G, The Maximum Transmit Unit is 1500
Internet Address is 10.0.12.2/24
IP Sending Frames’ Format is PKTFIT ETENT 2.Hardware address 1s 00e0-fc3b-2015
Current system time: 2019-03-04 10:24:29 -08:00
Last 300 seconds input rate 0 bits/sec, 0 packets/sec
Last 300 seconds output rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds input rate 0 bits/sec, 0 packets/sec
Realtime 0 seconds output rate 0 bits/sec, 0 packets/sec
Input: 6 packets, 574 bytes,
Output:7 packets, 638 bytes,
Input bandwidth utilization ;0%
Output bandwidth utilization :0%
——————————–
PortName Status Weight
——————————–
GigabitEthernet0/0/1 UP 1
GigabitEthernet0/0/2 UP 1
——————————–
The Number of Ports in Trunk : 2
The Number of UP Ports in Trunk : 2

NO.109 MIB (Management Information Base) is a virtual database that exists only in NMS.

NO.110 The Backup ports in RSTP may alternatively failed root port.

NO.111 Refer to the route-in-a-stick configuration in the figure below, it can be judged that the administrative department and the financial department can communicate with each other even if the ARP proxy is not enabled on the R1 sub-interface.

NO.112 The network shown below, it is desirable host traffic network administrator during planning A destined for host B data packets through the router between the G0/0/3 interfaces, the host B to the host PC A data packet through the router Between the G0/0/4 interface, which of the following commands can achieve this requirement? (Multiple choice)

NO.113 As shown in the figure, after the two routers are configured with OSPF, the administrator configures the <silent -interface s0/0/0> command on RTA, then the correct description of the following is (). (Multiple Choice)

NO.114 As shown in the figure, RTA uses NAT technology and realizes multiple-to-multiple NAPT address translation by defining an address pool, so that hosts in the private network can access the public network. Suppose that there are only two public IP addresses in the address pool, and they have been assigned to hosts A and B for address conversion, and if host C also wants to access the public network, which of the following description is correct?

NO.115 The network administrator uses Ping to test the connectivity of the network. Which of the following protocols may be used in this process? (Multiple choice)