[Q24-Q44] Exam Questions and Answers for HPE6-A72 Study Guide Questions and Answers!

4.2/5 - (4 votes)

Exam Questions and Answers for HPE6-A72 Study Guide Questions and Answers!

Aruba Certified Switching Associate Exam Certification Sample Questions and Practice Exam

Difficulty in Attempting Aruba Certified Switching Associate (HP HPE6-A72) Professional Exam

ACMA teaches the information, skills and practical experience needed to establish and configure a basic Aruba WLAN using the OS 8.X architecture and characteristics. This exam asks multiple questions on technical knowledge and hands-on experience of configuring a single Mobility Master with one controller and AP Aruba WLAN. Participants must study how to utilize Aruba hardware and ArubaOS to install and create an entire, secure controller network with multiple SSIDs.

The examination is scored based on a set standard built by Aruba Networks experts who are motivated by certification industry’s most reliable practices and guidelines.

This examination can not be instantly finished because the HP HPE6-A72 practice exam and HP HPE6-A72 practice test need to pass the examinations, these exam dumps require time and correct and up to date content to pass the exam with effectiveness. Several applicants are doubtful about the nature of questions posed in the exam and the complexity of exam questions and the time needed to finish the questions before writing a credential Professional certification. The most suitable way to pass the Professional Test is to question and prepare with HP HPE6-A72 practice exam and HP HPE6-A72 practice test.

NO.24 Refer to the exhibit

What is true regarding VLAN 50 according to the diagram above?

VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.

Since VLAN 50 has not been assigned to any enabled physical port, the status is down.

VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.

VLAN 50 was never added to the vlan-database and therefore is in a down state.

NO.25 What are the commands to disable SSH and HTTPS services from the default VRF?

Core-1(config)# no ssh server
Core-1(config)# no https-server

Core-1# no ssh server vrf default
Core-1# no https-server vrf default

Core-1(config)# no ssh server enable
Core-1(config)# no https-server enable

Core-1(config)# no ssh server vrf default
Core-1(config)# no https-server vrf default

NO.26 What are two OSPF attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)

Router ID

Priority

Hello and Dead intervals

Area ID

Process ID

NO.27 Which statement is true regarding modern switching requirements?

Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today’s power-over-Ethernet needs.

Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.

While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.

Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.

NO.28 Interface 1/1/1 is up
Admin state is up
Link transitions: 1
Description: TO_PC-1
Hardware: Ethernet, MAC Address: 00:11:22:33:44:55
MTU 1500
Type 1GbT
Full-duplex
qos trust none
Speed 1000 Mb/s
Auto-negotiation is on
Flow-control: off
Error-control: off
MDI mode: MDIX
VLAN Mode: access
Access VLAN: 1111
Which command will produce the above output?

show interface vlan 1111

show interface 1/1/1

show interface gigabit 1/1/1

show vlan 1111

NO.29 The customer has 778 developers testing computer games on the network.
Which two actions resolve Broadcast storms? (Choose two.)

Manually disable the redundant link to immediately resolve the impacted portion of the network.

Utilize Spanning Tree to dynamically disable all redundant links in a segment.

Setting switch ports to half-duplex will resolve Broadcast storms using Carrier Sense Multiple-Access Collision Detection (CSMA/CD).

Enable single Area Open Shortest Path First (OSPF) on all Layer 2 switches, but do not enable routing.

Utilize Spanning Tree to dynamically block Designated ports in addition to Alternate ports.

NO.30 You have completed a successful VSF stack between two switches.
Without manually assigning a backup switch, what is the expected output when issuing a show vsf command?

Option A

Option B

Option C

Option D

NO.31 The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

NO.32 Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

write memory

save

copy config config1 config startup-config

copy running-config startup-config

copy running-config checkpoint boot-config

NO.33 Which security benefit does SNMPv3 offer that SNMPv2 does not offer?

SSL encryption

Scopes

Data confidentially

RADIUS groups

NO.34 ServiceOS login: admin
SVOS> password
Enter password: ********
Confirm password: ********
The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above.
What is the default password that is required for the admin account while under the Service OS console?

No password is set for this account.

“password”

“forgetme!”

The same login password that has lost originally.

NO.35 Match the switching term to the correct definition.

NO.36 Click on the colored box that corresponds with the line that best represents Multicast traffic flow.

Explanation:
Blue Box

NO.37 Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.

NO.38 What command will save your configuration on an Aruba AOS-CX switch so that your changes automatically load on next reboot?

copy running-config checkpoint startup-config

copy startup-config running-config

copy running-config initial-checkpoint

copy running-config default

NO.39 Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)

allows transmissions of up to 4.8Gbps

is an emerging satellite connection standard to allow wireless access anywhere in the world

operates only in the 5GHz similar to 802.11ac

operates in both the 2.4GHz and 5GHz radios bands

is the first WLAN standard to no longer use electromagnetic signals to transmit data

NO.40 Match each network protocol to the correct server listening port. Not all answers will be used.

NO.41 What are two features of the three-tier designs? (Choose two.)

removes the distribution layer in favor of a spine-leaf design used in modern data center deployments

adds a distribution layer to free up resources from the Core for improved performance and routing throughput

a more scalable design over by leveraging a distribution layer to handle Layer 3 routing and access control in large deployments

uses only Layer 2 access on the Access and the Core with Layer 3 routing and access control provided at the distribution layer

is considered legacy by requiring a large flat layer-two broadcast domain from Core to Access and should be avoided

NO.42 Which two statements accurately describe stacking with Aruba switches? (Choose two.)

A VSF stack is allowed between an AOS-CX 6300M and 6300F switches.

VSF is a core or aggregation layer stacking technology due to the high resiliency of sharing a single control plane.

The VSF feature is not compatible between AOS-CX and AOS platforms.

A VSF stack is allowed between an AOS 5400R and an AOS-CX 6400.

VSF and VSX are stacking option with the AOS-CX 8320. 8325. 8400. and 6400 models.

NO.43 Refer to the exhibit.

What configuration is needed in order for “show LLDP configuration” to show this output?

none; LLDP is enabled by default on Aruba switches

configuring LLDP both globally and on the interfaces

enabling LLDP on the interfaces only

configuring LLDP globally only

NO.44 Refer to the exhibit.

Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?

11010101

10110001

01001011

11111000

Loading …

HPE6-A72 certification dumps – Aruba Certified Switching Associate (ACSA) V1 HPE6-A72 guides – 100% valid: https://www.testsimulate.com/HPE6-A72-study-materials.html

Difficulty in Attempting Aruba Certified Switching Associate (HP HPE6-A72) Professional Exam

Leave a Reply Cancel reply