Verified 300-620 &As – Provide 300-620 with Correct Answers [Q26-Q42]

NO.26 Which routing protocol is supported between Cisco ACI spines and IPNs in a Cisco ACI Multi-Pod environment?

NO.27 Refer to the exhibit. Server A is connected to the Cisco ACI fabric using two teamed interfaces.
One interface in a team is configured as active and the other remains in standby mode. When a failover occurs and the standby interface becomes active, it uses its built-in MAC address to send traffic. Which bridge domain configuration must be applied to resolve the issue?

NO.28 Drag and drop the Cisco ACI Layer 4 to Layer 7 service insertion terms on the left to the correct descriptions on the right.

NO.29 Refer to the exhibit.

An engineer must configure an L3Out peering with the backbone network. The L3Out must forward unicast and multicast traffic over the link. Which two methods should be used to configure L3Out to meet these requirements? (Choose two.)

NO.30 An engineer is extending EPG connectivity to an external network. The external network houses the Layer 3 gateway and other end hosts. Which ACI bridge domain configuration should be used?

NO.31 The customer is looking for redundant interconnection of the existing network to the new ACI fabric. Unicast and multicast traffic must be routed between the two networks. Which L3Out implementation meets these requirements?

NO.32 Which two protocols are used for fabric discovery in ACI? (Choose two.)

NO.33 Which method does the Cisco ACI fabric use to load-balance multidestination traffic?

NO.34 Refer to the exhibit. An engineer associated EPG-1 with a VMM domain called VMware/west. The VLAN pool west-VLP is configured in VMware/west, and the VMware/west is associated with the AEP called VMware/west-AEP. The corresponding port group failed to be automatically created in vCenter. Which action must the engineer take to resolve the missing port group?

NO.35 An engineer must set up a Cisco ACI fabric to send Syslog messages related to hardware events, such as chassis line card failures. The messages should be sent to a dedicated Syslog server.
Where in the Cisco APIC should the policy be configured to meet this requirement?

NO.36 An engineer is extending EPG connectivity to an external network. The external network houses the Layer 3 gateway and other end hosts. Which ACI bridge domain configuration should be used?

NO.37 What are two requirements for the IPN network when implementing a Multi-Pod ACI fabric?
(Choose two.)

NO.38 In the context of ACI Multi-Site, when is the information of an endpoint (MAC/IP) that belongs to site 1 advertised to site 2 using the EVPN control plane?

NO.39 An engineer is implementing a Cisco ACI data center network that includes Cisco Nexus 2000 Series 10G fabric extenders. Which physical topology is supported?
A)

B)

C)

D)

NO.40 An ACI administrator notices a change in the behavior of the fabric. Which action must be taken to determine if a human intervention introduced the change?

NO.41 Drag and drop the Cisco ACI filter entry options from the left onto the correct categories on the right indicating what are required or optional parameters.

NO.42 An engineer is implementing Cisco ACI at a large platform-as-a-service provider using APIC controllers,
9396PX leaf switches, and 9336PQ spine switches. The leaf switch ports are configured as IEEE 802.1p ports.
Where does the traffic exit from the EPG in IEEE 802.1p mode in this configuration?