Quality JN0-663 PDF Dumps – JN0-663 Exam Questions [Q24-Q44]

NEW QUESTION 24
Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

NEW QUESTION 25
Exhibit.

Referring to the exhibit, which command would reduce the size of the OSPF database and corresponding routes?
A)

B)

C)

D)

NEW QUESTION 26
Exhibit:

Referring to the exhibit, which three statements are correct? (Choose three.)

NEW QUESTION 27

You have an established Layer 3 VPN between two PE devices. You are asked to only send certain routes from PE-1 over the VPN to the remote site while maintaining all the routes on the PE-1 device. You created a policy that matches the specific routes and then tags these routes with the appropriate target community values.
In this scenario, which configuration changes must be made to satisfy the requirement?

NEW QUESTION 28
Exhibit:

Referring to the exhibit, the local BGP router is receiving IPv4 routes from the BGP neighbor, but it is not receiving L3 VPN routes from the BGP neighbor.
Which two actions should you take to solve this problem? (Choose two.)

NEW QUESTION 29
What information is stored in a VRF table for a BGP Layer 2 VPN? (Choose three.)

NEW QUESTION 30
Exhibit:

You have a Layer 3 VPN established between PE-1 and PE-2 as well as between PE-1 and PE-3. You are using a route reflector (RR-1) to distribute VPN routes to your IBGP peers. You are asked to ensure that only relevant routes are sent from RR-1 to each of the PE routers.
Referring to the exhibit, which statement is correct?

NEW QUESTION 31
Exhibit:

Referring to the exhibit, which three statements are correct? (Choose three.)

NEW QUESTION 32
Exhibit:

Referring to the exhibit, which two statements are correct? (Choose two.)

NEW QUESTION 33
Exhibit:



R4 is directly connected to both RPs (R2 and R3). R4 is currently sending all joins upstream to R3 but you want to load balance the joins between both RPs Referring to the exhibit, which configuration change will solve this issue?

NEW QUESTION 34
Exhibit:

Referring to the exhibit, which two statements are true? (Choose two.)

NEW QUESTION 35
Exhibit.

Referring to the exhibit, which two statements are correct for a route advertised by R1 towards R4? (Choose two )

NEW QUESTION 36
Which two statements regarding ingress replication in EVPN are correct? (Choose two.)

NEW QUESTION 37
Exhibit:

Referring to the exhibit, traffic sent from CE-A2 to PE3 does not loop back to CE-A2 through PE2.
Which two EVPN functions accomplish this task? (Choose two.)

NEW QUESTION 38
Exhibit:

You are receiving the same 200.0.0.0/24 BGP route from four different ISPs.
Referring to the exhibit, which ISP’s route would be selected as active?

NEW QUESTION 39
Exhibit:

You have an established Layer 3 VPN between two PE devices. You are asked to only send certain routes from PE-1 over the VPN to the remote site while maintaining all the routes on the PE-1 device. You created a policy that matches the specific routes and then tags these routes with the appropriate target community values.
In this scenario, which configuration changes must be made to satisfy the requirement?

NEW QUESTION 40
Exhibit:

R2 is receiving the same route from R1 and R3. You must ensure that you can load balance traffic for that route.
Referring to the exhibit, which two configuration changes will allow load balancing? (Choose two.)

NEW QUESTION 41
Exhibit:

Referring to the ABR configuration shown in the exhibit, which three statements are correct? (Choose three.)

NEW QUESTION 42
Exhibit:

You must configure an OSPF virtual link to facilitate communication between Area 0 and Area 20.
Referring to the exhibit, which two addresses should you use as the neighbor IDs of the virtual link endpoints?
(Choose two.)

NEW QUESTION 43
You want to allow the load balancing of traffic for an EBGP route from two different peers in the same AS.
Which three actions are needed to accomplish this task? (Choose three.)

NEW QUESTION 44
Exhibit:

Referring to the exhibit, which path would traffic passing through R1 take to get.