Get Perfect Results with Premium NSE7_SDW-6.4 Dumps Updated 82 Questions [Q17-Q32]

Rate this post

Get Perfect Results with Premium NSE7_SDW-6.4 Dumps Updated 82 Questions

Free NSE7_SDW-6.4 Exam Study Guide for the NEW Dumps Test Engine

To prepare for the Fortinet NSE7_SDW-6.4 exam, candidates can take advantage of various resources provided by Fortinet, including training courses, study guides, and practice exams. These resources are designed to help candidates develop a comprehensive understanding of the exam content and to provide them with the knowledge and skills needed to pass the exam.

NO.17 Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

NO.18 Refer to the exhibit.

What must you configure to enable ADVPN?

On the hub VPN, only the device needs additional phase one sett

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one

The protected subnets should be set to address object to all (0.0 .0. o/o).

NO.19 An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?

Choose the suitable interface based on the interface cost and weight

Configure an SD-WAN rule to load balance all traffic without VoIP

Use the performance SLA targets to detect latency and jitter instantly.

Place the troublesome link at the top of the interface preference list.

Select the corresponding SD-WAN balancing strategy in the SD-WAN rule

NO.20 Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

There are separate virtual interfaces for each dial-up client.

VPN static routes are prevented from populating the FortiGate routing table.

FortiGate created a single IPsec virtual interface that is shared by all clients.

100.64.3.1 is one of the remote IP address that comes through index interface 1.

NO.21 In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

Traffic has matched none of the FortiGate policy routes

Matched traffic failed RPF and was caught by the rule.

An absolute SD-WAN rule was defined and matched traffic

The FIB lookup resolved interface was the SD-WAN member interface

NO.22 Which two configuration tasks are required to use SD-WAN? (Choose two.)

Add one or more members to an SD-WAN zone.

Configure at least one firewall policy for SD-WAN traffic.

Specify the outgoing interface routing cost.

Specify the incoming interfaces in SD-WAN rules.

NO.23 Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

There are separate virtual interfaces for each dial-up client

FortiGate created a single IPsec virtual interface that is shared by all clients

100.64.3.1 is one of the remote IP address that comes through index interlace 1.

VPN static routes are prevented from populating the FortiGate routing table

NO.24 Refer to the exhibit.

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)

The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.

The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.

The traffic shaper drops packets if the bandwidth is less than 2500 KBps.

The measured bandwidth is less than 100 KBps.

NO.25 What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

Specify outgoing interface routing cost.

Configure SD-WAN rules interface preference.

Select SD-WAN balancing strategy.

Specify incoming interfaces in SD-WAN rules.

NO.26 Refer to the exhibit.

Which statement about the trace evaluation by FortiGate is true?

Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.

The packet exceeded the configured bandwidth and was dropped based on the priority configuration.

The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.

Packets exceeding the configured concurrent connection limit are dropped based on the priority

configuration.

NO.27 Refer to the exhibit.

Which conclusion about the packet debug flow output is correct?

The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.

The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.

The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.

NO.28 Which statement reflects how BGP tags work with SD-WAN rules?

BGP tags match the SD-WAN rule based on the order that these rules were installed.

BGP tags require that the adding of static routes be enabled on all ADVPN interfaces

Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag

VPN topologies are formed using only BGP dynamic routing with SD-WAN

NO.29 Which two tasks about using central VPN management are true? (Choose two.)

You can configure full mesh, star, and dial-up VPN topologies.

FortiManager installs VPN settings on both managed and external gateways.

You configure VPN communities to define common IPsec settings shared by all VPN gateways.

You must enable VPN zones for SD-WAN deployments.

NO.30 Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

NO.31 Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.
Which two configuration changes must be made to both IPsec
VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )

Configure a unique peer ID for each dial-up VPN interface

Use unique Diffie Hellman groups on each VPN interface

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode

NO.32 Refer to the exhibit.

Which statement about the trace evaluation by FomGate is true?

The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.

Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.

Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.

The packet exceeded the configured bandwidth and was dropped based on the priority configuration

Loading …

Fortinet NSE7_SDW-6.4 is an exam designed to test the knowledge and skills of individuals in the field of software-defined wide area network (SD-WAN) technology. This exam is part of the Fortinet Network Security Expert (NSE) certification program, which is a comprehensive set of exams designed to validate the skills and knowledge of network security professionals.

The Fortinet NSE7_SDW-6.4 exam covers a range of topics related to SD-WAN technology, including the fundamentals of SD-WAN, designing an SD-WAN solution, configuring and deploying SD-WAN, and troubleshooting SD-WAN issues. The exam also covers Fortinet products and solutions that are used in SD-WAN deployments, including FortiGate, FortiManager, and FortiAnalyzer. Candidates are expected to have a solid understanding of networking fundamentals, as well as experience working with Fortinet products and technologies.

NSE7_SDW-6.4 PDF Dumps Extremely Quick Way Of Preparation: https://www.testsimulate.com/NSE7_SDW-6.4-study-materials.html

Leave a Reply Cancel reply