Verified H35-211_V2.5 Dumps Q&As – H35-211_V2.5 Test Engine with Correct Answers [Q26-Q50]

Q26. Which of the following protocols is used to manage multicast member relationships?

Q27. (Radio) In the FTTB/C scenario, ONU is used as an AG device to access the phone, and there is no possible cause of sound failure for SIP protocol off-hook

Q28. (Single-choice) HSI service uses VLAM tags to bind users precisely, if there are 5K FTTH hanging under the LT Users, which VLAN switching scheme is recommended?

Q29. Type B protection provides redundant protection for both OLT PON ports and backbone fibers when OLT or
OLT PON If the port or trunk fiber fails, manually switch to another – luguang.

Q30. Under IGMP snooping, there are two users on demand under the OLT- the same program, and the olt sends
two join messages to the multicast router

Q31. In eSight’s ONT zero-configuration (zero-touch) deployment, do not provision the OLT when incrementally configuring the OLT.

Q32. (Radio) When configuring multicast services on MA5600T/MA5680T, the programs of multicast VLANs are
statically configured, and which of the following options must be configured, otherwise the multicast
programs may not be able to be watched

Q33. (Radio) When using the siP protocol, you need to use a local number graph for matching, if you use the default matching mode to match a 7-digit number beginning with 7727, then the following options are available?
The figure is

Q34. When the Type C dual home protection linkage uplink detection, if the OLT or OLT uplink fails, the Type C dual home protection can be reversed to another OLT

Q35. When the Type C dual-home protection linkage uplink detection is enabled, if the OLT or the OLT uplink fails, the Type C dual-home protection can switch over to another OLT.

Q36. Multicast technology effectively solves the problem of single-point transmission and multipoint reception, and realizes efficient data transmission from midpoint to multipoint in IP network.

Q37. (Radio) When configuring multicast services on MA5600T/MA5680T, the programs of multicast VLANs are statically configured, and which of the following options must be configured, otherwise the multicast programs may not be able to be watched

Q38. The scope of protection of the (multiple choice) GPON Type B dual attribution protection includes

Q39. Which of the following statements about Network Cloud Engine (NCE) are incorrect?

Q40. (Radio) To improve link reliability, the LT device uses two upstream ports 0/19/0 and 0/20/0 to configure a timedelay protection group. Which of the following commands is optional?

Q41. (Radio) When deploying GPON Type C single attribution protection, the following description is correct.

Q42. On a Layer 2 network, which protocol can be used to better control multicast traffic forwarding?

Q43. (Radio) Regarding multicast, the following description is incorrect

Q44. In a campus project, the XGS-PON technology is used, ONUs are used for AP backhaul, and 1:16 splitters are used. However, each splitter is connected to only 12 APs. In this case, what is the downstream concurrent bandwidth (Mbit/s) of each AP?

Q45. Under the H.248 protocol, if the signaling IP and media IP are both 10. 1 1 100/8, voice gateway is 10. 1 1 1.
When configuring voIP service, the following command is incorrect

Q46. Which of the following VLAN planning methods can be used in POL networking?

Q47. (Single choice) The following statement about the PITP protocol is incorrect

Q48. If a customer needs to protect the ONU trunk optical path but does not need to protect the ONU branch optical paths, which PON line protection mode should be used?

Q49. If multiple users connected to the same PON port of the OLT go offline, the possible cause is:

Q50. If the number of user ports configured in a service profile is different from that supported by an ONT, all user services on the ONT are unavailable.