Assume Fortinet NSE7_SDW-6.4 Dumps PDF Are going to be The Best Score [Q14-Q38]

Rate this post

Assume Fortinet NSE7_SDW-6.4 Dumps PDF Are going to be The Best Score

NSE 7 Network Security Architect NSE7_SDW-6.4 Exam and Certification Test Engine

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Topic	Details
Topic 1	Central management Configure SD-WAN SLAs
Topic 2	Configure SD-WAN rules Troubleshoot VPN and ADVPN
Topic 3	Centrally manage an SD-WAN infrastructure from FortiManager Configure basic SD-WAN setup
Topic 4	Implement a full or partially meshed redundant VPN infrastructure SD-WAN configuration

NEW QUESTION 14
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1

SD-WAN interface becomes disabled and port1 becomes the WAN interface

Dead members require manual administrator access to bring them back alive

Port2 might become alive when a single response is received from an SLA server

NEW QUESTION 15
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

Set priority 10.

Set cost 15.

Set load-balance-mode source-ip-ip-based.

Set source 100.64.1.1.

NEW QUESTION 16
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

Per-IP shaping mode

Reverse policy shaping mode

Interface-based shaping mode

Shared policy shaping mode

NEW QUESTION 17
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

Traffic has matched none of the FortiGate policy routes

Matched traffic failed RPF and was caught by the rule.

An absolute SD-WAN rule was defined and matched traffic

The FIB lookup resolved interface was the SD-WAN member interface

NEW QUESTION 18
Which statement about using BGP routes in SD-WAN is true?

Adding static routes must be enabled on all ADVPN interfaces.

VPN topologies must be form using only BGP dynamic routing with SD-WAN

Learned routes can be used as dynamic destinations in SD-WAN rules

Dynamic routing protocols can be used only with non-encrypted traffic

NEW QUESTION 19
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )

A peer ID is included in the first packet from the initiator, along with suggested security policies

The use of Diffie Hellman keys is limited by the responderand needs initiator acceptance

XAuth is enabled as an additional level of authentication which requires a username and password

A total of six packets are exchanged between an initiator and a responder instead of three packets.

NEW QUESTION 20
Refer to exhibits.

Exhibit B.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic however inbound traffic is not being evaluated by the shaping policy Based on the exhibit, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic’?

The reverse shaper option must be enabled and a traffic shaper must be selected

The guaranteed-10mbps option must be selected as the reverse shaper option.

A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

The guaranteed-10mbps option must be selected as the per-IP shaper option

NEW QUESTION 21
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

The dead member interface stays unavailable until an administrator manually brings the interface back.

The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Port2 needs to wait 500 milliseconds to change the status from alive to dead.

Check interval is the time to wait before a packet sent by a member interface considered as lost.

NEW QUESTION 22
Refer to the exhibit.

FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)

Specify a unique peer ID for each dial-up VPN interface.

Use different proposals are used between the interfaces.

Configure the IKE mode to be aggressive mode.

Use unique Diffie Hellman groups on each VPN interface.

NEW QUESTION 23
Refer to exhibits.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

The reverse shaper option must be enabled and a traffic shaper must be selected

The guaranteed-10mbps option must be selected as the reverse shaper option.

A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

The guaranteed-10mbps option must be selected as the per-IP shaper option

NEW QUESTION 24
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager

NEW QUESTION 25
Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

set cost 15.

set source 100.64.1.1.

set priority 10.

set load-balance-mode source-ip-based.

NEW QUESTION 26
Refer to the exhibit.

What must you configure to enable ADVPN?

On the hub VPN, only the device needs additional phase one sett

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one

The protected subnets should be set to address object to all (0.0 .0. o/o).

NEW QUESTION 27
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?

diagnose sys virtual-wan-link health-check

diagnose sys virtual-wan-link log

diagnose sys virtual-wan-link sla-lcg

diagnose sys virtual-wan-link intf-sla-log

NEW QUESTION 28
Refer to exhibits.

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)

The implicit rule overrides all other rules because parameters widely cover sources and destinations.

SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.

The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.

The initial session of an application goes through a learning phase in order to apply the correct rule.

NEW QUESTION 29
Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two )

FortiGate provides statistics and readings based on historical traffic logs.

This traffic shaper drops traffic that exceeds the set limits.

The debug output shows per-lP shaper values and real-time readings.

Traffic being controlled by the traffic shaper is under 1 Kbps

NEW QUESTION 30
Refer to exhibits.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)

All the existing sessions that do not use SNAT will be flushed and routed through port1.

All the existing sessions will continue to use port2, and new sessions will use port1.

All the existing sessions using SNAT will be flushed and routed through port1.

All the existing sessions will be blocked from using port1 and port2.

NEW QUESTION 31
Which components make up the secure SD-WAN solution?

Application, antivirus, and URL, and SSL inspection

Datacenter, branch offices, and public cloud

FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy

Telephone, ISDN, and telecom network.

NEW QUESTION 32
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.

Each IP is guaranteed a minimum 10 Mbps of bandwidth

A single user uses the allocated bandwidth divided by total number of users.

The 10 Mbps bandwidth is shared equally among the IP addresses.

NEW QUESTION 33
Which statement reflects how BGP tags work with SD-WAN rules?

BGP tags match the SD-WAN rule based on the order that these rules were installed.

BGP tags require that the adding of static routes be enabled on all ADVPN interfaces

Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag

VPN topologies are formed using only BGP dynamic routing with SD-WAN

NEW QUESTION 34
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)

It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.

It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.

It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.

It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.

NEW QUESTION 35
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

The shaper mode must be applied per-IP shaper on the traffic shaping policy

The application control profile must be enabled on the firewall policy.

The web filter profile must be enabled on the firewall policy

The URL category must be specified on the traffic shaping policy

NEW QUESTION 36
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology

Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )

Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.

The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN

London generates an IKE information message that contains the Toronto public IP address

NEW QUESTION 37
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

The FortiGate cloud key has not been added to the FortiGate cloud portal.

FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

The zero-touch provisioning process has completed internally, behind FortiGate.

FortiGate has obtained a configuration from the platform template in FortiGate cloud.

A factory reset performed on FortiGate.

NEW QUESTION 38
What is the lnkmtd process responsible for?

Monitoring links for any bandwidth saturation

Processing performance SLA probes

Flushing route tags addresses

Logging interface quality information

Use NSE7_SDW-6.4 Exam Dumps (2022 PDF Dumps) To Have Reliable NSE7_SDW-6.4 Test Engine: https://www.testsimulate.com/NSE7_SDW-6.4-study-materials.html

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

Leave a Reply Cancel reply